Sag fox float rp23 series#

Test the proper operation of your front and rear brakesДЄnd set sag, and compare your result to the sag setting shown in the Air Spring Setting Guidelines table.

Check that all brake cables or hoses are properly.

To your bicycle manufacturer's recommendations. Pinch bolts) are properly adjusted and tightened.

Make sure that your quick-release levers (or thru-axle.

Shock should not be used if any of the exterior parts appear to be damaged.

Inspect the entire exterior of your shock.

Do not use a high pressure washer on your shock. NOTE:Do not use any solvents or de-greasers, as these products can damage the shock's exterior finish or its anodized parts.Дo not spray water directly on the seal/shock body junction.

Clean the outside of your shock with only mild soap and water,.

CheckД«e performed by FOX Racing Shox or an Authorized Other things to consider for all shock models:Д¬onditions, service your shock and air sleeve more frequently. This is an indication that the air sleeve should be re-lubricated. If this residual air sleeve lubricant is not present, There may be a small amount of air sleeve lubricant residue on the body. Tune to a more specific air pressure in the Setting Of the shock are clear of the frame and swingarm as it cycles throughДЄir chamber to a minimum of 50 psi and no more than 300 psi. If you are installing your shock on a bike for which the shock is notД¬hamber air cap and let all the air out of the main air chamber.

RP2 Remote: Kashima coat, remotely actuated ProPedal В®, boost valve, air spring pressure, rebound, angled air valve for easier access, lightweight chassis. RP23: Kashima coat, 3-position ProPedal В® Adaptive Logicв„ў tuning range adjust (0-open,1-light, 2-medium), 2-position ProPedal В® actuation lever (firm, switching to open or light or medium), boost valve, air spring pressure, rebound, angled air valve for easier access, lightweight chassis. SagВ | Setting SagВ | Adjusting ReboundВ | ProPedalВ | Stuck Down ShockВ | Air Sleeve MaintenanceВ | Service IntervalsВ | Important Safety InformationДҐ.5 x 1.0 6.0 x 1.25 6.5 x 1.5 7.5 x 2.0 7.875 x 2.0 7.875 x 2.25 8.5 x 2.5 Installing Your ShockВ | General MaintenanceВ | Before You RideВ | Measuring

Sag fox float rp23 series#

You are here: Rear Shocks > FLOAT > FLOAT - Factory series